ATC200 LITE DRIVER DOWNLOAD

Select OK Figure Please choose your search and [If the default file was used at installation, enter C: Old versions cannot talk to newer firmware on actuators. OK Finish Table Other types may ground the dc voltage, preventing voltage from reaching the actuator, TMA, etc. In the long run, this may be faster than testing components individually.

Uploader:	Zuluzilkree
Date Added:	3 July 2010
File Size:	33.94 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	44038
Price:	Free* [*Free Regsitration Required]

Record antenna serial number and actuator serial number s for each antenna. Open Word and paste Cntl V. If there is no communication, the actuator can be field replaced or the entire antenna assembly can be returned depending on the customer preference.

ATCLITE-USB Teletilt Portable RET RS to RS RET Controller - Talley Inc.

If failure still exists, bypass the junction box and retest. This is no longer available with Vista. If key does not point to center of actuator, connector may have been twisted so that pins have no internal contact. Andrew disclaims any liability or responsibility for the results of improper or unsafe installation practices. Cases have been seen in the field where an incorrectly installed or malfunctioning cable can cause an actuator to be missed during a device scan.

Andrew Atc200 - Lite USB Ret Controller

The antenna definition file is included with download bundles for rack mount controllers. If the Lit port is connected to a smart bias tee, the signal may be scrambled and hamper communication. The suffix of an antenna indicates the operating mode of factory-installed actuators. Register and select Get Software.

All actuators can move the full range in less than 25 seconds. See pages iii to v, the main Table of Contents, for the product in each section and issues related to the product. After the checks listed above, see also: TMAs also do not have these parameters.

Improper Site Installation - Example 3. Permanent ac200 Actuator shaft on antenna is not moving properly Return complete antenna assembly.

Select Browse my computer for driver software. When turning on the controller power and the green LED is flickering, turn the power off immediately. It is recommended that transmit power be turned off when the field installation is performed.

Software Updates

Do not use metal ladder. Follow all applicable safety precautions as shown on this page.

Wait for programs to be listed. This section describes correcting this problem. Open Universal Serial Bus controllers tree Figure atc2000 These controllers can be operated using a standard Internet browser to facilitate remote access from the network operations center.

See below to locate and download installation bulletins online from the Commscope website: This can be checked at the AISG female cable assembly. Wtc200 Hardware Wizard window will open. For example, each wall could have an antenna with an actuator. Select Manage Network Connections link Figure Voltage level should be close to 24 Vdc. You may need to introduce a dc block in the line.

No weather proofing is required.